Thursday, September 7, 2017

Proper use of automobile tires and routine maintenance tips


Tire Repair Install Tool Plu

1. Proper use of timely and effective maintenance can prevent irregular tire damage.

(1) Always check the tire nuts in case they are missing or loose.

(2) Check the tire pressure to see if it is qualified, if the valve leaks, if the valve caps are complete and so on.

(3) Carefully check the tire for cracks, holes or other injuries.

(4) Preparation of a tire repair kit, such as pry tires bars, hand hammer, jack, tire socket wrench,   the barometer and other tire materials.


For sure, there is another important tool we need to prepare inside our tool kit all the times - the Tire Repair Install Tool Plug which is made by chrome stainless steel for car tire reparation and installment.

 
Tire Repair Install Tool Plu

2. Following points should observe while driving
(1) Car should not start too excessively in order to reduce the slipping for the wheel on the ground. If the vehicle started too quickly, even invisible wheel slip can be generated increasing tire wear.

(2) Cars on the bad roads of complexity, the speed should be adjusted according to the road conditions. When driving on the road arch, you should try to keep the car in the middle of the road to avoid the unilateral tire force. At the same time try to avoid the emergency brake to slow tire wear.

(3) When driving in the summer, temperature is higher, do not lower the pressure, do not use cold water pouring on it. The best way is to rest a few times on the way, and at an appropriate driving speed.

(4) When driving, anytime there is a feeling of body roll or steering directed to the side, must stop immediately and check the tire pressure.

(5) When driving over an obstacle (such as rails, stones, etc.), reducing the speed as much as possible and going through carefully, so as not to puncture the tires.

(6) Do not drive close to the curb or sidewalk, while avoiding getting deeper into the lane as much as possible so as not to damage the sidewall.

(7) Do not immediately accelerated in cold conditions (in particular when the tire temperature is below -30 ~ -40 ) and should be driven at the speed of 5--7km / h within the first 20--30min until  the tire temperature rises and then increases speed.

(8) Loading must be a balanced distribution of the goods, do not overload the vehicle, the load should be evenly distributed on each tire.





No comments:

Post a Comment